So,
Following from the start of the 4M Transverter project I posted about last time:
http://g0mgx.blogspot.co.uk/2015/04/transverting-even-more.html
I've done some more today.
The power amp module is built and mounted on the rear of the enclosure with an aluminium heat spreader:
![]()
The rest of the enclosure is prepared:
![]()
![]()
Following from the start of the 4M Transverter project I posted about last time:
http://g0mgx.blogspot.co.uk/2015/04/transverting-even-more.html
I've done some more today.
The power amp module is built and mounted on the rear of the enclosure with an aluminium heat spreader:
.JPG)
The rest of the enclosure is prepared:
.JPG)
.JPG)
The internal wiring is almost complete, I've just run out of SMA cables - which is a bit of a bummer! I'm also waiting for the ZLPLL from here to complete the project properly.
Not a bad start though, egh?